 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| FSTD16861 20-Bit Bus Switch with Level Shifting May 2001 Revised June 2005 FSTD16861 20-Bit Bus Switch with Level Shifting General Description The Fairchild Switch FSTD16861 provides 20-bits of highspeed CMOS TTL-compatible bus switching. The low On Resistance of the switch allows inputs to be connected to outputs without adding propagation delay or generating additional ground bounce noise. A diode to VCC has been integrated into the circuit to allow for level shifting between 5V inputs and 3.3V outputs. The device is organized as a 10-bit or 20-bit bus switch. When OE1 is LOW, the switch is ON and Port 1A is connected to Port 1B. When OE2 is LOW, Port 2A is connected to Port 2B. When OEX is HIGH, a high impedance state exists between the A and B Ports. Features s 4: switch connection between two ports. s Minimal propagation delay through the switch. s Low lCC. s Zero bounce in flow-through mode. s Control inputs compatible with TTL level. s TruTranslation voltage translation from 5.0V inputs to 3.3V outputs s Power-off high impedance inputs and outputs s Supports live insertion/withdrawal (Note 1) Note 1: To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pull-up resistor; the minimum value of the resistor is determined by the current-sourcing capability of the driver. Ordering Code: Order Number FSTD16861MTD Package Number MTD48 Package Description 48-Lead Thin Shrink Small Outline Package (TSSOP), JEDEC MO-153, 6.1mm Wide Devices also available in Tape and Reel. Specify by appending the suffix letter "X" to the ordering code. TruTranslation is trademark of Fairchild Semiconductor Corporation. (c) 2005 Fairchild Semiconductor Corporation DS500421 www.fairchildsemi.com FSTD16861 Connection Diagram Logic Diagram Pin Descriptions Pin Name OE1, OE2 1An, 2An 1Bn, 2Bn Description Bus Switch Enables Bus A Bus B Truth Table Inputs OE1 L L H H OE2 L H L H Inputs/Outputs 1A, 1B 1A 1A Z Z 1B 1B 2A Z 2A, 2B 2A Z 2B 2B H HIGH Voltage Level L LOW Voltage Level Z High Impedance www.fairchildsemi.com 2 FSTD16861 Absolute Maximum Ratings(Note 2) Supply Voltage (VCC) DC Switch Voltage (VS) (Note 3) DC Input Voltage (VIN) (Note 4) DC Input Diode Current (lIK) VIN 0V DC Output Current (IOUT) DC VCC/GND Current (ICC/IGND) Storage Temperature Range (TSTG) 0.5V to 7.0V 0.5V to 7.0V 0.5V to 7.0V 50 mA 128 mA Recommended Operating Conditions (Note 5) Power Supply Operating (VCC) Input Voltage (VIN) Output Voltage (VOUT) Input Rise and Fall Time (tr, tf) Switch Control Input Switch I/O Free Air Operating Temperature (TA) 0 ns/V to 5 ns/V 0 ns/V to DC -40 qC to 85 qC 4.5V to 5.5V 0V to 5.5V 0V to 5.5V r100 mA 65qC to 150 qC Note 2: The "Absolute Maximum Ratings" are those values beyond which the safety of the device cannot be guaranteed. The device should not be operated at these limits. The parametric values defined in the Electrical Characteristics tables are not guaranteed at the absolute maximum rating. The "Recommended Operating Conditions" table will define the conditions for actual device operation. Note 3: VS is the voltage observed/applied at either the A or B Ports across the switch. Note 4: The input and output negative voltage ratings may be exceeded if the input and output diode current ratings are observed. Note 5: Unused control inputs must be held HIGH or LOW. They may not float. DC Electrical Characteristics VCC Symbol VIK VIH VIL VOH II IOZ RON Parameter Clamp Diode Voltage HIGH Level Input Voltage LOW Level Input Voltage HIGH Level Input Leakage Current OFF-STATE Leakage Current Switch On Resistance (Note 7) ICC Quiescent Supply Current 5.5 10 (V) 4.5 4.5-5.5 4.5-5.5 4.5-5.5 5.5 0 5.5 4.5 4.5 4.5 4 4 35 See Figure 3 2.0 0.8 Min TA 40 qC to 85 qC Typ (Note 6) Max Units V V V V IIN Conditions 1.2 18 mA r1.0 10 PA PA PA : : : mA 0 d VIN d 5.5V VIN VIN VIN VIN OE1 VIN OE1 VIN 5.5V 0V, IIN 0V, IIN 2.4V, IIN OE2 OE2 64 mA 30 mA 15 mA 0 0 GND VCC 0 d A, B d VCC r1.0 7 7 50 1.5 VCC or GND, IOUT VCC or GND, IOUT PA mA ' ICC Increase in ICC per Input 5.0V and TA 5.5 25qC 2.5 One Input at 3.4V Other Inputs at VCC or GND Note 6: Typical values are at VCC Note 7: Measured by the voltage drop between A and B pins at the indicated current through the switch. On Resistance is determined by the lower of the voltages on the two (A or B) pins. 3 www.fairchildsemi.com FSTD16861 AC Electrical Characteristics TA Symbol Parameter CL 40 qC to 85 qC, RD 500: Units Conditions Figure Number VCC 4.5 - 5.5V Max 0.25 ns ns ns VI VI VI VI VI OPEN 7V for tPZL OPEN for tPZH 7V for tPLZ OPEN for tPHZ Figures 1, 2 Figures 1, 2 Figures 1, 2 50pF, RU Min tPHL, tPLH tPZH, tPZL tPHZ, tPLZ Propagation Delay Bus-to-Bus (Note 8) Output Enable Time Output Disable Time 1.0 1.0 6.0 7.0 Note 8: This parameter is guaranteed by design but is not tested. The bus switch contributes no propagation delay other than the RC delay of the typical On Resistance of the switch and the 50pF load capacitance, when driven by an ideal voltage source (zero output impedance). Capacitance Symbol CIN CI/O Note 9: TA (Note 9) Parameter Typ 3 6 Max Units pF pF VCC Conditions 5.0V, VIN 0V 0V Control Pin Input Capacitance Input/Output Capacitance "OFF State" 25qC, f VCC, OE 5.0V, VIN 1 Mhz, Capacitance is characterized but not tested. AC Loading and Waveforms Note: Input driven by 50: source terminated in 50: Note: CL includes load and stray capacitance Note: Input PRR 1.0 MHz, tW 500 ns FIGURE 1. AC Test Circuit FIGURE 2. AC Waveforms www.fairchildsemi.com 4 FSTD16861 Output Voltage HIGH vs. Supply Voltage FIGURE 3. 5 www.fairchildsemi.com FSTD16861 20-Bit Bus Switch with Level Shifting Physical Dimensions inches (millimeters) unless otherwise noted 48-Lead Thin Shrink Small Outline Package (TSSOP), JEDEC MO-153, 6.1mm Wide Package Number MTD48 Technology Description The Fairchild Switch family derives from and embodies Fairchild's proven switch technology used for several years in its 74LVX3L384(FST3384) bus switch product. Fairchild does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and Fairchild reserves the right at any time without notice to change said circuitry and specifications. LIFE SUPPORT POLICY FAIRCHILD'S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body, or (b) support or sustain life, and (c) whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury to the user. www.fairchildsemi.com 6 2. A critical component in any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness. www.fairchildsemi.com |
Price & Availability of FSTD1686105
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |